Positive Pressure Units for apartments, flats and houses without access to a loft system
Product Specification
The PP2FLAT positive pressure unit is suitable for apartments and houses that do not have access to a loft. Providing whole house ventilation, the unit is ideal for eliminating mould and condensation and requires limited ducting. PP2LOFTHR/HL models are available with additional heaters for added comfort in colder months.
Benefits
Models & Control options
Ancillaries
Installation
The PP2FLAT/H is a discreet and compact unit that is designed to be installed in a convenient location - usually in an airing cupboard, above kitchen cupboards or in hallway - and requires limited ducting.
- Ideal solution for Section 82 Environmental Protection Act 1990 cases – continuous problems with condensation and mould growth
- Low running costs for occupants – as low as 5 W/l/s in operation which equates to less than a penny a day to run!
- Interchangeable and multi-positional spigots for airflow provide a flexible solution for all property layouts
- Moderates unwanted infiltration and reduces unnecessary heat loss
- Integral grade GU3 filter for fresh filtered air and provision of good indoor air quality
- Simple to install and very low on-going maintenance
- Centrally mounted ceiling diffuser for discreet internal aesthetics
- Three airflow settings for complete flexibility and differing dwelling sizes
- Five year warranty
- Can be used for Radon control where required in the UK
- PP2FLATHR and PP2FLATHL have a thermostatically controlled heater for added comfort during the coldest months
Ancillaries for PP2FLAT/H:
- PIV duct
- PP1SWITCH
- PP2FIL
Wiring: Must comply with IEE Regulations
Cable: Supplied with a pre-wired power supply
Consumption:
PP2FLAT:
Low speed - 3.1W
Medium speed - 5.7W
High speed - 9.4W
PP2FLATH:
See performance table
Fuse: 3 amp
Electrical specification:
240V 1ph 50Hz
Ducting connections: Ø100mm or 121 x 60mm